Unique features of Rageforce machinery plastic injection machines

Standard Features

• PLC system
• Semi-automatic controller
• Servo System for high stabilize, high efficient, outstanding energy saving, reduced noise lavel)
• VDP System for more holding pressure & energy saving
• A/C drive for energy saving
• Larger opening stroke mould capacity and tie bar distance to accommodate large moulds
• Graded casting platen, toggle, brackets and links with harden pin and bush
• Multi stage injection with speed & pressure
• Multi stage mould opening and closing speed & pressure
• Gas nitride steels screw barrel and cavity
• Part dropping sensor for single part
• Hydraulic& pneumatic core pulling system
• S.S. hopper with magnet grill
• Cold start protection
• Centralize lubrication systems
• Air valve
• Water manifold 4 in/out
• Hydraulic ejector
• Hydro motor for opening mold thread
• Electrical and hydraulic (dump valve) interlock safety gate
• Energy meter
• Oil temperature indicator
• Oil cooler (water cooling type)

Unique injection units

Injection units is movable. It will transport the melted plastic material into the mold. So its movement of mechanical structure will consume a lot of energy, which is partly composed of the main cost. Then how should we do to reduce the cost for customers? To reduce its energy consumption, we adopt new design idea of lightweight on Fuhrung series injection unit. Meanwhile, we optimized its mechanical movement by equipping liner guid rails.

1. The moving parts of the injection unit get a faster injection speed because of lightweight and low-friction.
2. It is more easier to control injection position
3. Dual designed carriage cylinders ensure good balance and get high precise injection.
4. No welding designed hydraulic circuit for injection unit, easy for maintain & no leaking.
5. Lightening designed moving parts for injection, easy to get the fast start injection speed, and meet high speed injection needs.
6. Dual linear guide rails, ensure high precise & reduce friction to get more power saving.
7. Full supported injection unit base, high rigidity and long lifespan.
8. Double cover for barrel heater, it will be useful to avoid operators to be scalded.

• Twin cylinder injection unit (uniform load distribution across screw centreline)
• High torque piston hydro motor
• Multi stage injection with variable speed & pressure
• Liner transducer to control programmable injection position
• Programmable holding pressure profile
• Programmable multi stage refilling
• Automatic purging
• Gas nitrated hardened screw and barrel
• High efficiency and low power rate ceramic heater with Insulated
• Heater disconnection indicator
• Cold start screw prevention
• Pre-suck back function
• PID temperature control
• Ampere meter for heater
• Sliding mechanism for hopper
• Screw back pressure control valve